Ok crafters....here's our first lesson of the season! Today we'll be making Pumpkin Luminaries! This is a pretty easy project to get your fangs wet, jumping back into the project pool.
Here's what you'll need:
•Krylon Fusion for Plastic® - Pumpkin (Safety) paint
•Krylon Fusion for Plastic® - Sunbeam (#2330) paint
•Two 2-liter empty plastic soda bottles
•Con-Tact® Paper
•Scissors
•Xacto® knife
•Adhesive remover
•2 candles
•Sand
•Paper towels
•Newspaper
•Rubber Gloves (optional)
Here's what you'll do:
1.Peel label from empty plastic soda bottle. Use adhesive remover and a paper towel to remove any residue.
2.Wash soda bottles thoroughly; let dry completely.
3.Using Xacto knife, carefully cut off top of bottle. Cut a half-circle out of the back, near the bottom; this will make it easier to add the sand and the candle.
4.Draw facial features on contact paper and cut out. Adhere features to the soda bottle, being careful to firmly seal edges with fingernail.
5.Cover work area with newspaper. Spray soda bottles with Krylon Fusion – one with Pumpkin Orange and the other with Sunbeam. Let dry for 3 hours.
6.When completely dry, carefully peel off contact paper features. (Note: Krylon Fusion will be dry to touch after 15 minutes but should be allowed to cure for at least 24 hours before the luminaries are put into service.)
7.Add sand to base for weight and insert candle. Light and enjoy.
For more project ideas, please visit favecrafts.com
